NOTE: To remove plate: Lay the machine on it’s back again
and disengage cross-complete from driving plate by turning cross-
complete, and lining up notches until plate slips free.
WARNING: Increased heating of the grinding tooling and
equipment may occur due to the increase of grinding speed, increase
of pad diameter, or grinding with or without water.
NOTE: Adding water to the machine will increase weight of
machine.
d. Return the machine to upright position and adjust handle to
operating position. Lock the handle pin into position
2. If the dust skirt fell o while changing tools be certain to re-
install.
Preparing the Machine
Perform the steps listed below to prepare your machine for
operation.
1. To attach appropriate grinding tools to G-250XTP:
a. Make sure handle is in an upright “locked” position.
b. Lay the machine on its back with the handle lying on the oor;
this exposes the driving plate on the underside of the machine.
CAUTION! Always place hands in center of handlebars when
lowering and raising machine! This method increases stability and
reduces the risk of machine tilting as its re-positioned.
c. From a standing position at side of
machine put metal bond plate or resin
plates on the cross-complete. Turn the
cross-complete lock in either direction to
lock the plate into place.
*
*
NEVER kneel in front of upended machine to replace tools.
*
PREPARING THE MACHINE
24/7 Technical Support- Toll Free 1-877-472-8200
14
Concrete Polishing Solutions- G-250XTP Operator’s Manual
To Next Page
Loading...