How to Operate the Machine
The G-250XTP is intended for use by a professional. As such,
this section is intended to guide the operator through the operation
of the G-250XTP. It is not intended as instruction on the grinding
or polishing of oors. The term “plates” is used to mean any of the
attachments (metal bond plates, resin plates, etc.) applicable to the
process.
The following steps should be done after following the
instructions in Preparing the Machine:
1. Adjust handlebars to desired height and grasp rmly.
2. Stand behind G-250XTP with feet planted rmly on even ground.
3. Press the ‘START’ button to engage the engine while slowly turning
the throttle counter clockwise.
CAUTION! Do not start the machine while the head is in the
upright position.
CAUTION! Always check that dust skirt is properly attached
and secured before starting the machine.
4. Select desired RPM using the throttle.
IMPORTANT! Never hold the machine in one place while the
machine is on. The G-250XTP must remain in constant motion.
Holding machine still may cause “swirling” damage to oor.
*
*
HOW TO OPERATE THE MACHINE
24/7 Technical Support- Toll Free 1-877-472-8200
16
Concrete Polishing Solutions- G-250XTP Operator’s Manual
To Next Page
Loading...