The G-250XTP has been designed by the engineers at Concrete
Polishing Solutions to be the most innovative in grinding and polishing
technology. We have used our experience in the industry to create a
grinder/polisher that combines practicality and durability.
The grinding head assembly (A), contains the engine (A: 1),
the grinding plates and the gear drive assembly. The grinding plates
are part of the revolutionary three-head grinding system designed
by CPS. This new system contours to the oor’s surface, reducing
rigidity, allowing your tools to more eectively follow with the oor’s
surface and lowering initial diamond costs. These drive plates can be
tted with a number of attachment tools (metal bonds, resin bonds,
etc.), depending on the surface to be worked.
The gear drive system has been designed with a ring and
pinion gear as well as a heavy duty belt that eliminates slipping and
extends the life of the machine. We have paid special attention to the
designing of the upper and lower external seals for the head, which
prevents dust from getting into the internal seal and locking up the
bearings. Both the grinding plates and the gear drive assembly are
enclosed in a safety shroud (A: 2) which has two dust exhaust ports
(A: 3) to be used when dry grinding.
The chassis (B) comprises of a water tank (B: 1) and a start
and E-stop control box (B: 2). The water tank is large enough to hold
approximately 10.5 gallons of water. The water is gravity fed and
released by using the water valve (B: 3) located at the bottom of the
water tank.
The G-250XTP is unique in that the weights (C) are attached to
the frame, which prevents loss while maintaining an orderly job site.
They provide 150 lbs (75 lbs each) of additional weight and are located
on both sides of the machine. They can be lowered independently
on either side to help cut the edge more eciently.
The frame of the machine extends above the chassis and holds
the adjustable handle bars (D) and the machine’s throttle cable. It is
connected by use of two (2) bolts to attach to the grinding head (A)
with loose tting hardware allowing the head to be free oating.
ABOUT YOUR MACHINE
24/7 Technical Support- Toll Free 1-877-472-8200
10
Concrete Polishing Solutions- G-250XTP Operator’s Manual
To Next Page
Loading...