ATTENTION: This book has been prepared to provide information and
suggestions for Operators in their operation of the G-250XTP grinder &
polisher.
It is not intended that the suggestions in this booklet take precedence
over existing job-site safety rules and regulations, or OSHA regulations.
However, a thorough study of the following information should provide a
better understanding of safety for people and machinery on the job-site.
It must be recognized that this is a booklet of suggestions for the Operator’s use.
It is the responsibility of the owner to make personnel aware of all federal, state,
SAFETY MESSAGES
24/7 Technical Support- Toll Free 1-877-472-8200
9
* Always wear personal protective gear (respirator, dusk
mask) when operating the machine with out a vacuum
system.
* Obey all safety signs and instructions when operating or
maintaining equipment.
* Keep children and pets away from your grinder and polisher
at all times.
* Always wear a properly tting particle mask, appropriate for
this application, as specied by OSHA regulations.
* Always make sure to use the appropriate dust interceptor
when performing dry grinding operations.
* Use only water in the water tank. Any chemicals added may
cause material breakdown, which may then lead to leakage.
Leaks can get into electrical components, creating hazards
and causing injuries.
* When lling the tank with water, be careful to avoid all
electrical components, and avoiding dangerous reactions.
* Wear a suitable protective device such as earplugs. Loud
noise can cause impairment or loss of hearing.
* Keep the electrical parts of the machine dry. For storage,
keep the machine in a building.
Concrete Polishing Solutions- G-250XTP Operator’s Manual
To Next Page
Loading...