CPS G-250XTP - Best Practices

To Next Page

To Previous Page

Best Practices

In order to optimize performance, CPS recommends the

following:

When grinding with the G-250XTP, one should do a forward pass

followed by a back pass.

1. Using 40 grit metal bond diamonds

• Run G-250XTP between 2,400-2,500 RPMs.

• Foot Speed – Very Slow and Constant

2. Using 80 grit metal bond diamonds

• Run G-250XTP between 2,400-2,500 RPMs.

• Foot Speed – Very Slow and Constant

3. Using 150 grit metal bond diamonds:

• Run G-250XTP between 2,400-2,500 RPMs.

• Foot Speed – Slow and Easy, Natural walking pace

4. Using 100 grit resin bond diamonds

• Run G-250XTP between 2,800 - 2,900 RPMs.

• Foot Speed – Slow and Easy – Natural walking pace

5. Using RD Disc Technology

• Run G-250XTP at full RPMs.

• Foot Speed – Slightly faster than resin bond tools.

NOTE: Use only CPS recommended grinding tooling and

equipment. Contact CPS for any further information.

Phone: 877-472-8200 * E-mail: info@go2cps.com

Each oor is dierent and requires the operator to have a certain

amount of expertise in determining which tools are appropriate for

each job.

However, CPS is happy to discuss any questions or concerns regard-

ing the G-250XTP and the grinding and polishing process.

Please feel free to contact our Customer Service Department.

BEST PRACTICES

24/7 Technical Support- Toll Free 1-877-472-8200

Concrete Polishing Solutions- G-250XTP Operator’s Manual