Cradlepoint IBR650 - Page 60

CRADLEPOINT IBR650| USER MANUAL Firmware ver. 3.3.0
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 58
Ethernet Port Configuration
Ethernet Port Configuration provides
controls for your router‘s Ethernet ports.
There are two ports: one set as LAN and
one set as WAN. While default settings
will be sufficient in most circumstances,
you have the ability to control: Mode
(WAN or LAN) and Link Speed.
Additional controls for WAN ports are
available in Internet → Ethernet
Settings.
Mode: WAN or LAN.
 Internet (WAN) is used to connect
to another network such as a hotel or office wired network. The WAN connection is used as a possible source of
internet for the IBR650.
 Local Network (LAN) is for connecting a computer or similar device directly to the router with an Ethernet cable.
Link Speed: Default setting is Auto. The Auto setting is preferred in most cases.
 Auto
 10Mbps - Half Duplex
 10Mbps - Full Duplex
 100Mbps - Half Duplex
 100Mbps - Full Duplex
 1000Mbps - Full Duplex