12
TEST RUN
Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
Remove all the tools used for assembling
the machine components. Walk around the
machine, ensure all nuts, bolts, and screws
are tightened and the machine is properly
assembled. Connect the cord to the power
source and turn the machine ON.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates, turn OFF the power
switch immediately and disconnect the cord
from the power source. Investigate if you
can find out the problem with your machine.
DUST COLLECTION
The CX118 features a 4” diameter dust port
to collect to a dust collector.
Figure-12 Dust port
When using a dust collector, use the proper
sized hose and make sure all the
connections are sealed tightly.
It is recommended to use a proper sized
dust collector with CX118 to ensure
adequate dust collection.
WARNING!
This machine can perform many types of
operations which are beyond the scope
of this manual and are very dangerous if
performed incorrectly. The safety
instructions given in this manual can not
be complete because the environment in
every shop is different. Always consider
safety first as it applies to your individual
workin
condition
.
WARNING!
Before starting the band saw, make sure
that you have read and understood the
instructions given in the manual and you
are familiar with the functions and safety
features on this machine. Failure to do
so may cause serious personal injury.
WARNING!
The saw dust produced by the band saw
can go into your lungs and cause serious
health problems. Make sure the band
saw is connected to a dust collection
system while operating it.
To Next Page
Loading...
