Why is my Craftex Air Cleaner motor overheating?
If the motor of your Craftex Air Cleaner is overheating, it could be due to using the wrong voltage. Check the voltage and the voltage label. Another possible reason is a damaged motor, which would need to be checked and replaced.
How to fix a shaking Craftex Air Cleaner?
If your Craftex Air Cleaner is shaking, it might not be properly anchored or secured; mount it securely in place. Another cause could be that the unit isn't level, so adjust it. Also, a worn or damaged motor can cause shaking, so check and replace the motor if necessary.
What to do if Craftex Air Cleaner motor does not run when power is switched on?
If the motor of your Craftex Air Cleaner doesn't run when you switch it on, the fuse may have blown and needs replacing. Alternatively, the switch could be burned out, requiring replacement. Another potential cause is a loose or damaged wire connection, which should be tightened or replaced.
Why Craftex Air Cleaner motor will not reach full power?
If your Craftex Air Cleaner motor won't reach full power, the power wiring might be incorrect; replace or correct it. Another possibility is that an overload has tripped; reduce the load by cleaning the filters as necessary.
How to troubleshoot Craftex Air Cleaner motor that does not run at full speed?
If the motor of your Craftex Air Cleaner isn't running at full speed, the power voltage might be too low; test the voltage. Alternatively, the motor could be damaged, requiring a check and replacement.
Why does my Craftex Power Tool motor go off during a cut?
The motor might be overloaded during usage, so you should take lighter cuts and decrease the load. There could also be a short circuit in the motor or no connection, in which case you should call an electrician to fix or replace connections on the motor for faulty terminals or damaged insulation. Another potential cause is a moved circuit breaker; set up the correct circuit breaker and decrease the amount of machines used on that circuit.
What to do if my Craftex Power Tool motor overheats?
Overheating can occur if the motor is overloaded during usage. Try taking lighter cuts and decreasing the motor's load. Another cause might be no air flow through the motor. Wipe out the motor to provide normal air flow.
Why won't my Craftex Power Tool motor turn on?
First, check the outlet source to ensure the tool is properly plugged in. If that's not the issue, the fuse may be blown, in which case you should have the fuse replaced, reset the breaker, or call an electrician. Also, make sure the lockout key is properly replaced. Finally, check to ensure you are using the proper voltage.
Why does my Craftex Power Tool keep burning fuses?
A short circuit in the cord or plug could be the reason. Call an electrician to fix or replace the cord or plug for shorted wires. Also, the unit may be overloaded. Lower the load and use a circuit different from other household appliances, or use a circuit that has a high amp rating.
What to do if my Craftex Power Tool motor fails to increase full power?
The issue may be an overloaded circuit with lights, motors, and appliances; decrease the load on the circuit. Alternatively, there may be short wires or circuits that are too long; get a longer wire or decrease the length of the circuit.
General| Motor Power | 15 Amp |
|---|---|
| Voltage | 120V |
| Blade Diameter | 12 in |
| Max Cutting Depth | 4 in |
| Motor | 15 amp |
| Blade Size | 12 in |
To Next Page
