12
TEST RUN
Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source and troubleshoot to
determine the problem with your machine.
See page-13 for Troubleshooting.
WORK-PIECE INSPECTION
CX501 is designed to sand wood ONLY.
Do not use this machine to sand metals,
glass or stone etc.
Before sanding, make sure to inspect the
work-piece for nails, staples, small pieces
of stone or metal and any other foreign
objects.
Sanding the work-piece with this kind of
objects can tear the sanding paper. For a
safe cutting method always inspect your
work-piece carefully before cut and wear
eye protection.
Some woods with excessive finish or glue
load up the sand paper and reduce its
usefulness. Use an abrasive cleaner to
clean the sanding paper.
MAINTENANCE
1. Clean the machine daily after use.
2. When the machine is not in use, turn the
switch off and remove the switch key.
3. A build-up of dust in the motor can
cause motor damage. Periodic cleaning
of the motor is not only recommended,
but also mandatory for normal sander
performance.
4. Keep the machine and attachments
clean.
5. All bearings are permanently lubricated
and require no further lubrication.
Before starting the sander, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
READ THE
MANUAL
Abrasive Cleaners
Model# 15154
Model# 15158
To Next Page
