Craftsman 113.226640 User Manual

Save This Manual
For Future Reference
MODEL NO.
113.226640
SAW WITH LEGS AND
TWO TABLE EXTENSIONS
Serial
Number
Model and serial
number may be found
at the rear of the base.
You should record both
model and serial number
in a safe place for
future use.
CAUTION:
READ ALL
INSTRUCTIONS
CAREFULLY
IO-INCH
DIRECT DRIVE
TABLE SA W
• assembly
• operating
= repair parts
Sold by SEARS, ROEBUCK AND CO., Chicago, IL. 60684 U.S.A-
Part No. 62969

Craftsman 113.226640 Specifications

General

Model Number	113.226640
Type	Table Saw
Blade Diameter	10 inches
Voltage	120V
No Load Speed	5000 RPM

Summary

GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS

ADDITIONAL SAFETY INSTRUCTIONS FOR TABLE SAWS

MOTOR SPECIFICATIONS AND ELECTRICAL REQUIREMENTS

UNPACKING AND CHECKING CONTENTS

ASSEMBLY

ASSEMBLY OF STEEL LEG SET

Instructions for assembling the steel legs for the saw.

Blade Tilt, or Squareness of Blade to Table

Adjusting the blade's angle for square or bevel cuts.

Attaching and Assembling Table Extensions

Instructions for adding table extensions for increased workspace.

Installing Rip Fence Guide Bars and Switch

Mounting the rip fence guide bars and the on/off switch.

Installing Blade Guard

Properly fitting and securing the safety blade guard.

Adjusting Miter Gauge

Setting up the miter gauge for accurate angle cuts.

BASIC SAW OPERATION

Using the Miter Gauge

Techniques for making cuts using the miter gauge.

Using the Rip Fence

Operations performed using the rip fence for lengthwise cuts.

Ripping

Cutting wood lengthwise along the grain.

Bevel Ripping

Ripping wood at an angle to the surface.

MOTOR

MAINTENANCE

TROUBLE SHOOTING -- GENERAL

TROUBLE SHOOTING -- MOTOR

SERVICE

HOW TO ORDER REPAIR PARTS

Information on obtaining replacement parts and servicing.