Craftsman 113.27520 User Manual

.....:,,,,,,,:....... i, , i i J ii i,ii ,,, .......
OP_RATUNG INSTRUCTIONS
AND PARTS LIST FOR
(
W
C
@
r
Model Number
113.27520
The above Model Number will be found on a plate attached to
your sa_, at the back, near the bottom of the base. Always men-
tion the Model Number when communicating with us regarding
your saw or when ordering parts,
.... Ordering Information tor ................... •
Retail and Mail Order Stores
1. Send all ol:rders for parts listed herein direct to:
.... 7% ......
A minimu_ ,_?, source on any
order amou _:¢ ,_:,_ __. ,,,i/._:_ i! s to be charged
the actual F___. _ ........ '_ :¢'
Markut_: Selling prices on the parts listed produce a markalp of
approxtmately AO.
Filing Instructions
File this parts list immediately behind parts list nttmber 113.22411
in the DIVISION 9 Standard Nomenclature GREY BINDER Vol, II
Printed in U S A
ii
$_AR$, ROEgUCK AND CO.

Craftsman 113.27520 Specifications

General

Model Number	113.27520
Type	Table Saw
Blade Diameter	10 inches
No Load Speed	3450 RPM
Arbor Size	5/8 inches
Table Size	27 inches x 20 inches
Rip Capacity	24 inches

Summary

Craftsman Bench Saw 10-Inch Tilting Arbor Operating Instructions

Ordering and Filing Information

Ordering Information for Retail and Mail Order Stores

Instructions on how to order parts from retail and mail order stores.

Filing Instructions

Guidance on where to file the parts list for easy reference.

Saw Assembly and Initial Setup

Uncrating and Part Inspection

Steps for uncrating the saw and checking for all parts.

Assembly and Cleaning Procedures

Instructions for assembling loose parts and cleaning the saw table.

Arbor Nut and Blade Alignment

Ensuring the arbor nut is tight and the blade aligns with table grooves.

Rip Fence Installation and Alignment

Steps to install and adjust the rip fence parallel to the saw blade.

Motor Mounting and Operating Controls

Motor Mounting and Tension Adjustment

How to mount the motor and adjust belt tension for optimal operation.

Miter Gage Placement

Guidance on correctly placing the miter gage in the table grooves.

Motor Specifications and Safety Cautions

Details on recommended motors and critical safety warnings.

Overview of Operating Controls

Description of the function of each control on the saw.