Craftsman 113.27521 User Manual

OPERATING INSTRUCTIONS
AND PARTS LIST FOR
C
|smqE
10-inch Tilting Arbor
, , Model Number
113.27521
The above Model Number will be found on a plate attached to
your saw, at the back, near the bottom of the base. Always men-
tion the Model Number when communicating with us regarding
your saw or when ordering parts.
Instructions for Ordering Parts
All parts listed herein must be ordered through a Sears retail store
or mail order house. Parts are shipped prepaid. When ordering
repair parts, always give the following information:
1. The part number.
2. The part name.
3. The model number,
This list is valuable. It will assure your being able to obtain
proper parts service. We suggest you keep it with other valuable
papers.
........... ii i • i
i i

Craftsman 113.27521 Specifications

General

Model Number	113.27521
Type	Table Saw
Blade Diameter	10 inches
Motor Power	1.5 HP
Voltage	120V
No Load Speed	3450 RPM
Table Size	20 x 27 inches
Max Cut Depth at 90°	3-1/8 inches
Arbor Size	5/8 inches
Amps	15 Amps

Summary

Craftsman Bench Saw Assembly and Operation

Rip Fence Installation and Alignment

Assembling and Adjusting Components

Motor Mounting and Belt Tension

Steps for attaching the motor, aligning pulleys, and setting belt tension.

Operating Adjustments

Gage and Fence Adjustments

Proper Operating Procedures and Safety

Personal Safety and Attire

Guidelines on dressing, alertness, and blade height for safe operation.

Safe Workpiece Handling

Advice on avoiding awkward positions and preventing kickback during cuts.

Standard Saw Operations

Ripping Wood Technique

Cutting wood along the grain using the rip fence for guidance.

Resawing Thick Boards

Crosscutting Wood Technique

Cutting wood across the grain using the miter gage.

Specialized Saw Operations

Bevel and Miter Cuts

Using the Dado Head Attachment