To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 315.23743 and is the answer not in the manual?
General| Model Number | 315.23743 |
|---|---|
| Type | Circular Saw |
| Blade Diameter | 7-1/4 inches |
| No Load Speed | 5, 000 RPM |
| Cord Length | 6 ft |
| Depth of Cut at 45 degrees | 1-3/4 in |
Explains the concept of double insulation in power tools for user protection.
Emphasizes reading and understanding all manual instructions before operation to prevent accidents.
Lists essential safety rules for operating the miter saw, covering personal safety and work area management.
Lists the basic hand tools needed for assembling and adjusting the miter saw.
Provides instructions for safely removing the saw from its packaging and performing initial checks.
Details how to securely mount the miter saw to a workbench or leg set for stability.
Step-by-step instructions for correctly installing the saw blade onto the spindle.
Guides on checking and adjusting the saw's bevel angle for precise cuts.
Instructions for aligning the saw blade with the turntable slot for accuracy.
Covers front-to-rear alignment of the saw blade with the saw head movement.
Steps to set the fence parallel to the blade for accurate 45°/90° cuts.
How to align the right fence with the left fence for consistent cutting.
Adjusting the miter detent lever for precise angle stops.
Procedures for adjusting the blade guard for proper operation and safety.
Reinforces safety warnings and essential operating procedures for the miter saw.
Detailed steps for safely starting, cutting, and stopping the saw, including brake usage.
How to adjust and use the miter arm for various angle settings.
Instructions for setting and using the bevel post for angled cuts.
Guidance on using table extensions and clamps for secure and safe cutting.
Overview of various cutting tasks performable with the miter saw.
Techniques for accurately cutting various types of mouldings.
How to cut common framing lumber like 2x4s and 2x6s.
Instructions for making compound angle cuts for roof rafters.
Advice on safely cutting thin materials such as plastics and composition board.
Steps for cutting plastic pipe cleanly and accurately.
Best practices for cutting bowed materials to avoid blade pinching.
How to perform miter cuts for shapes with multiple sides.
Specific settings required for cutting crown moulding.
Guidance on performing complex cuts using both miter and bevel angles.
Instructions for replacing worn motor brushes to maintain performance.
Instructions for replacing the saw's switch and power cord.
Procedures for safely removing the blade and general blade maintenance tips.
Guidance on securing the saw for storage or transport.
How to clean sawdust and adjust turntable tension for smooth operation.
Instructions for lubricating key components and adjusting for motor wear.
Lists compatible accessories for the saw.
Solutions for when the saw fails to power on.
Troubleshooting steps for issues with the mechanical brake.
Addresses problems with the blade not reaching full operating speed.
Solutions for preventing or fixing excessive saw vibration.
Tips for achieving clean and smooth cuts.
How to avoid the blade getting pinched in the material.
Solutions for inaccuracies in miter and cross cuts.
Troubleshooting steps for achieving precise bevel cuts.
Solutions for a stiff or difficult-to-rotate miter arm.
