Craftsman C459-52213 - Drift Cutters; Lamp Wiring Harness; Tire Pressure

10
ASSEMBLY
Drift Cutters (If Equipped)
Drift cutters should be used when operating the snow thrower in heavy
drift conditions.
• Onmodelssoequipped,driftcuttersandhardwareareassembled
to the auger housing inverted.
• Removethecarriageboltsandhexnutssecuringthedriftcuttersto
the housing.
• RepositiondriftcutterssotheyfaceforwardasshowninFigure14.
Secure with hardware previously removed.
If your unit is not equipped with drift cutters, you may contact
1-800-4MY-HOME for information regarding price and availability.
Lamp Wiring Harness (If equipped)
The post on the cable tie attaching the lamp wiring harness to the
lower handle should be plugged into the hole in the lower handle. Pull
the slack portion of the wiring harness through the cable tie to prevent
interference with the recoil starter handle. See Figure 15.
Figure 14
Figure 15
Tire Pressure
The tires are over-inflated for shipping purposes. Check the tire
pressure before operating the snow thrower. Refer to the tire side wall
for tire manufacturer’s recommended psi and deflate (or inflate) the
tires as necessary.
WARNING
Under any circumstance do not exceed manufacturer’s recom-
mended psi. Equal tire pressure should be maintained at all times.
Excessive pressure when seating beads may cause tire/rim
assembly to burst with force sufficient to cause serious injury. Refer
to sidewall of tire for recommended pressure.