6
SECTION: E WARRANTY REPAIR
E-1) Information Needed:
ALWAYS furnish the following information:
1. Pump Part Number
2. Pump model number
3. Pump date code
E-2 Part Number:
The part number consists of a six (6) digit number, which
appears in the catalog. A one or two letter suffi x may
follow this number to designate the design confi guration.
This number is used for ordering and obtaining informa-
tion.
E-2 Model Number:
This designation consists of numbers and letters which
represents the horsepower, motor phase and voltage, and
pump design. This number is used for ordering and obtain-
ing information.
E-3 Date Code:
The Date Code consists of two numbers which are
punched holes in the nameplate. This specifi es the month
and year which indicates the date the unit was built.
SERVICE PARTS AVAILABLE - LEVEL CONTROLS:
113647 Vertical Float 10 Ft. Piggy Back
113647A Vertical Float 20 Ft. Piggy Back
106929 Mech. Wide Angle 10 Ft. Piggy Back
101758XA Mech. Wide Angle 20 Ft. Piggy Back
Pumps Sold as Complete Units Only, Except for
Above Listed Level Controls
60 Hz
Testing is performed with water,
specifi c gravity of 1.0 @ 68° F, other
fl uids may vary performance
To Next Page
Loading...
