4.5 Daily Cleaning & Filling Procedure
Important: It is necessary to carry out the cleaning and maintenance procedure outlined on the
following pages on a daily basis.
4.5.1 Ingredient Canisters - Removal and Cleaning
1. Rotate canister outlets to upright position. Remove the
ingredient canisters. DO NOT place them on the floor.
2. With a clean, damp sanitised cloth wipe the exterior of
the canisters. Ensure canister outlets are dried
thoroughly after cleaning.
4.5.2 Mixing and Steam Extraction System
1. Remove the dispense pipe from the mixing bowl. Rotate
the steam trap to clear the extract housing and remove
from the mixing system.
2. Remove the mixing system by turning the green locking
lever to the left and pull the mixing system away from
the back plate.
3. Pull off the impeller and the rubber seal.
4. Clean all of the mixing system parts, including the steam
traps, mixing bowls and dispense pipes thoroughly in the
diluted bactericidal cleaner solution. Rinse all components
with clean water and dry thoroughly.
5. Remove the extract tray from the machine. Using a dry
brush, clean the area under the extract tray.
6. Clean the extract tray. Dry and refit to the machine.
Wipe the canister shelf and the upper interior of the
machine with a clean, damp sanitised cloth.
To Next Page
Loading...
