Clean the Oltre brewer chassis and mounting area.
Clean all of the Oltre brewer components.
Rinse all components with clean water, dry then refit to machine.
Weekly Cleaning Procedure
Important: Cleaning and maintenance outlined on the following pages must be carried out
on a weekly basis.
Check that the Oltre brewer(s) are in an open position, if not then press ‘2’ on the service
keypad, the brewer will move and will stop at the open position
Remove the brewer chamber & filter belt assembly, then remove the belt. Clean all
components with the recommended mix of de-staining solution; soak for 5 to 10 minutes.
Rinse all parts thoroughly in clean water & re-assemble into the machine.
Press the service keypad Brewer Clean button (4) and the machine will flush the brewer.
Empty the brewer waste container. Wash the waste container thoroughly.
N.B. If the feature has been turned on when the brewer waste container is emptied the
waste counter must be reset. To reset the waste counter press button 12 on the
service keypad, two audible bleeps confirm that the counter has been reset to zero.
To Next Page
Loading...
