Quick to use
01. When the mixer is turned off, select one MIC/ LINE input channel, plug in the microphone or CD player
and other external audio source to connect to the mixer, please make sure before connecting
Keep the access channel mute or push the physical push to the lowest position.
02. Power on the mixer and wait for the power on. Please use the power adapter provided by the original
manufacturer.
03. After starting the mixer, adjust the volume of the corresponding channel to the appropriate position,
and send the signal to the corresponding output.
4. Finally adjust the gain size.
05. If you are connected to a capacitive microphone or other device that requires power, turn on the
Phantom Power.
06. According to the demand of the signal source, the equalizer is used to enhance or weaken the
corresponding frequency band, and the compressor and threshold are used to control the dynamic
range.
07. Send input signals to each effector, output bus and main output.
8. Change the volume knob until the sound system produces the right amount of sound.
4
To Next Page
Loading...