5. Matters Needing Attention and Maintenance
1. The power adapter of Creality 3D Pad is 5V/1A;
2. To avoid errors, please unplug the original screen while using
Creality 3D Pad
3. Please plug printer and Creality 3D Pad separately, make sure
that the printer is plugged earlier than Creality 3D Pad, or at the
same time at least.
4. Creality 3D Pad comes with filament run-out sensor, plug and
print. The original sensor will be disabled.
5. Creality 3D Pad works with Marlin Firmware FDM printers,
and single-hotend printers;
6. To preview models on Pad, the printing model has to be
sliced by Creality 3D Pad-v3.3.1.-10-win64-Alphaon.
To Next Page
Loading...
