Creality Ender 3 Pro - Page 21

Creality Ender 3 Pro Assembly Instructions V1.0 21 www.rb42.blog
Step 7 - Hot-end carriage and Z-axis passive block
Tools for this
step
M2.5 Hex Key (Allen Key)
Parts for this
step
1x (04) Z-axis passive block
1x (05) Hot-end carriage
Fixings
2x M4x16 hex socket button head screw w/ captive
washer
Consumables
Loctite 222
Process
7.1
Slide the (05) Hot-end carriage over the end of the (18) X-axis
profile, ensuring the V-slot wheels go into the channel of the
aluminium extrusion, with two wheels being on top and the
single wheel at the bottom. The (05) Extruder carriage is
oriented with a majority of the assembly (fans, hot-end and
cover) on the front side of the (18) X-axis profile, opposite side
to that of the (06) XE stepper motor kit assembly already
attached (from step 5).