1. Prepare →Auto Home. Wait for the nozzle to move to the
left/front of the platform.
2. Prepare→Disable Steppers(Close stepper drive，release
motor)
3. Move the nozzle the front/left leveling screw and adjust the platform
height by turning the knob underneath. Use a piece of A4 paper (standard
printer paper) to assist with the adjustment, making sure that the nozzle
lightly scratches the paper.
4. Co
mplete the adjustment of the screw on all 4 corners.
5. Repeat above steps 1-2 times if necessary.
1 2
34
G、Bed Levelling
12
To Next Page