Creality Ender-7

10. Solution for V-wheel jamming of heated bed plate 热床板V轮卡顿解决方案
15
Gently dial the V-wheel manually to check whether it is idling. If idling happens, please use an open-ended wrench to
adjust the off-center separation pillar according to the illustrated direction, so that the V wheel is not idling.
用手轻拨V轮，检查其是否有空转，如有此现象请使用开口扳手按图示方向调节偏心隔离柱，使V轮无空转。
Click back to the origin in the interface after power-on, and then go on moving the Z axis independently. Put your hand on
the printing platform to observe whether the platform is stuck. If it is, please adjust the off-center separation pillar in the
opposite direction according to the illustrated direction to make the V-wheel move smoothly.
通电在界面点击回原点，回原点后单独移动Z轴。将手放在打印平台上，观察平台是否有卡顿现象，如有卡顿按图示方向的反方向调节
偏心隔离柱使其运动顺畅。