This machine can print at a fast speed, but it is recommended to print at normal speed!Notes: the temperature of the nozzle is set according to the
printing speed. Take PLA as an example:
本机器支持高速打印，但建议以正常速度打印！ 注意：不同速率时，喷嘴打印温度需相应调整设置，创想配送PLA推荐设置参数：
The printing temperature is different owing to the variety of PLA filaments. Please refer to the actual situation.
打印温度会存在些许差异，请根据实际打印情况适当调整。
Cutting speed
切片速度
60mm/s 125mm/s 250mm/s
Nozzle temperature
喷嘴温度
Around 200℃
200℃左右
Around 210℃
210℃左右
Around 220℃
220℃左右
14. Start Printing 开始打印
23
To Next Page
Loading...
