EasyManua.ls Logo

Crem EX2 - Machine Alerts; Alarms and Warnings

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
Original instructions.
· Alarms and warnings
To alert users that routine service of the machine is due or against a situation that could possibly cause
damage to the machine, EX-Line has the following alerts programmed into its software:
Display
Code
Machine status Alarm Name
Warning
/ Alarm
Solution
[AL1]*
Machine blocked and all
touchpads buttons blink
NTC is short-
circuited
Alarm Replace NTC
[AL2]*
Machine blocked and all
touchpads buttons blink
NTC is not con-
nected
Alarm Replace NTC
[AL3]
Selected button blinks
and brew must be
stopped manually
No ow detected
on this group
Warning Check owmeter
[FiL]
Machine blocked and all
touchpads buttons blink
Steam Boiler
FillingUp timeout
Alarm
Turn the main switch o and on again.
Check that the machine is receiving water
[Eco]
Touchpads lights o
Boiler temperature is
decreased to 105ºC
Eco mode status Warning
Press any button from K1 to K4 to ’wake up’
the machine
[oFF]
Touchpads lights o
Boiler element
disconnected
Stand-by mode
status
Warning
Press any button from K1 to K4 to ’wake up’
the machine
[SEr]
Machine works
Static message on group 1
Service
maintenance
alarm
Warning
Call service specialist to perform
maintenance routine.
To reset the service alarm counter:
- Keep pressed K1+K2 and turn the machine
on by the main switch.
- Message [rSE] will be shown on Group 1
[FiL]
Machine works
Static message on group 1
Water lter
maintenance
alarm
Warning
Call service specialist to perform
maintenance routine.
To reset the service alarm:
- Keep pressed K3+K4 and turn the machine
on by the main switch.
- Message [rFi] will be shown on Group 1
Display versions
MACHINE ALERTS
Machine status Alarm Name
Warning
/ Alarm
Solution
Selected button blinks and brew must
be stopped manually
No ow detected
on this group
Warning Check owmeter
Machine blocked and all touchpads
buttons blink
Steam Boiler
FillingUp timeout
Alarm
Turn the main switch o and on again.
Check that the machine is receiving
water
Control versions
*For SmartSteam machines: ALX/Ste = Steam boiler, ALX/SS = SmartSteam wand.

Related product manuals