39 • IV-CAMA3-20-N-W-1B, IV-CAMA3-20-N-SLVR-1B, IV-CAMA3-20-W-1B, and IV-CAMA3-20-
SLVR-1B
Product Manual — Doc.
9323C
To draw a Tracking Zone:
1. Click Tracking in the lower half of the settings panel. The cursor will move into the video frame.
2. While holding down the left mouse button, drag the mouse to draw the tracking zone.
3. Let go of the left mouse button to release the cursor from the video frame.
4. Once the Tracking Zone is set, click Save to store the setting in the camera’s memory.
Set the Blocking Zone
Set Blocking Zones within the Tracking Zone to prevent projection screens, windows, or moving objects
from triggering the camera’s motion detection. Up to 8 blocking zones can be configured.
Guidelines:
l
Blocking Zones are only active within the Tracking Zone and will not have an effect outside of the
Tracking Zone.
l
Set the Blocking Zone so it does not block an entire section of the tracking zone as this could
potentially cause the camera to lose the presenter if they remain in the blocked area for too long.
l
There should be space left in the Tracking Zone under the Blocking Zone so that motion can be
tracked as the person walks in front of the display or window you are blocking.
l
Use Blocking Zone 7 or 8 for environments where a presenter will stand in front of a display or
projection screen. Blocking Zones 7 and 8 are customized to prioritize motion detection over face
detection.
To Next Page
Loading...
Need help?
General
