Crestron 2 Series - Page 54

2-Series Integrated Dual Bus Control System Crestron AV2 & PRO2
EEPROM
Description: This command displays the current parameters stored in EEPROM.
Help Menu(s): Device
Syntax: Eeprom
Parameters: none
Possible Source: RS-232, CTP, Telnet
ERRLOG
Description: This command prints a list of the most recent errors.
Help Menu(s): System
Syntax: ERRlog
Parameters: none
Possible Source: RS-232, CTP, Telnet
ESTATUS
Description: This command displays the status of the Ethernet link (Link on/off, link speed, full duplex on/off). Also it
displays the settings for the Ethernet card.
Help Menu(s): Ethernet, System
Syntax: ESTatus
Parameters: none
Possible Source: RS-232, CTP, Telnet
ETHERNET
Description: This command enables/disables the Ethernet card. A reboot is required before the command is effective.
Help Menu(s): Ethernet, System
Syntax: ETHERNET [ON | OFF]
Parameters: ON - enables the Ethernet card
OFF - disables the Ethernet card
Possible Source: RS-232, CTP, Telnet
ETHERTEST
Description: This command runs the various diagnostic tests for the Ethernet card.
Help Menu(s): Ethernet, System
Syntax: ETHERTEST [RESET | REGTEST | MEMTEST | LOOPBACK | MMUTEST | INTTEST | EETEST | FULL |
EXTLOOP | REGMAP | SHOWTX | SHOWRX | EEDUMP]
Parameters: RESET - reset Ethernet chip
REGTEST - perform register test
MEMTEST - perform memory test
LOOPBACK - perform local loopback test
MMUTEST - perform memory management unit test
INTTEST - perform interrupt test
EETEST - perform EEPROM test
FULL - perform all the above tests
EXTLOOP - perform external loopback test
REGMAP - display all the registers
SHOWTX - display the last transmitted packet
SHOWRX - display the last received packet
EEDUMP - perform EEPROM test
Possible Source: RS-232
50 • Integrated Dual Bus Control System: PRO2 & AV2 Operations Guide - DOC. 5957