2-Series Integrated Dual Bus Control System Crestron AV2 & PRO2
RTSCTS
Description: This command enables/disables the hardware handshaking on the RS-232 port. If no parameter is entered, the
current state is displayed.
Help Menu(s): System
Syntax: RTScts [ON | OFF]
Parameters: ON - enables the RTS/CTS handshaking
OFF - disables the RTS/CTS handshaking
Possible Source: RS-232, CTP, Telnet
SAVE
Description: This command forces a system parameter save to EEPROM.
Help Menu(s): Main, System
Syntax: SAVE
Parameters: none
Possible Source: RS-232, CTP, Telnet
SELFTEST
Description: This command executes the system self test procedure.
Help Menu(s): Device
Syntax: SELFTEST
Parameters: none
Possible Source: RS-232, CTP, Telnet
SERIAL
Description: This command sets the communication parameters for the
COMPUTER
port. New settings are effective
immediately.
Help Menu(s): System
Syntax: SERial baud,parity,databits,stopbits
Parameters: baud - desired baud rate for the RS-232 port (110 through 115200)
parity - desired parity for the port ('N', 'E', 'O')
databits - desired number of data bits (7,8)
stopbits - desired number of stop bits (1,2)
Possible Source: RS-232, CTP, Telnet
SHOWHW
Description: This command displays the current hardware configuration as well as the current Internet settings.
Help Menu(s): Main, System
Syntax: SHOWHW
Parameters: none
Possible Source: RS-232, CTP, Telnet
SYSTEM
Description: This command initiates a firmware upgrade using Xmodem to transfer the new firmware to the panel. The user
is prompted to start the Xmodem transfer (not allowed over a Telnet connection).
Help Menu(s): File, System
Syntax: SYSTEM
Parameters: none
Possible Source: RS-232, CTP
54 • Integrated Dual Bus Control System: PRO2 & AV2 Operations Guide - DOC. 5957
To Next Page
Loading...
