Crestron MC3 3-Series Control System™
Uploading and Upgrading
Crestron recommends using the latest programming software and that each device
contains the latest firmware to take advantage of the most recently released features.
However, before attempting to upload or upgrade it is necessary to establish
communication. Once communication has been established, files (for example,
programs or firmware) can be transferred to the control system (and/or device).
Finally, program checks can be performed (such as changing the device ID or
creating an IP table) to ensure proper functioning.
While the next section provides an overview for communication, refer to
“Establishing Communications with the Control System” in the Crestron 3-Series
Control Systems Reference Guide (Doc. 7150) for connection details. If
communications cannot be established, refer to “Troubleshooting Communications”
in the same guide.
Establishing Communication
Use Crestron Toolbox for communicating with the MC3; refer to the Crestron
Toolbox help file for details. There are two methods of communication: USB and
TCP/IP.
USB
USB Communication
The COMPUTER port on the MC3 connects to the USB port on the PC via the
included Type A to Type B USB cable:
1. Use the Address Book in Crestron Toolbox to create an entry using the
expected communication protocol (USB). When multiple USB devices are
connected, identify the MC3 by entering “MC3” in the Model textbox, the
unit’s serial number in the Serial textbox or the unit’s hostname in the
Hostname textbox. The hostname can be found in the “System Info”
window in the section marked Ethernet however, communications must be
established in order to see this information in the “System Info” window.
2. Display the MC3’s “System Info” window (click the
icon);
communications are confirmed when the device information is displayed.
Operations Guide – DOC. 7095D 3-Series Control System™: MC3 • 19
To Next Page
Loading...
Need help?
General
