3-Series Control System™ Crestron MC3
Operation
Configuring for Operations
Before setting up the MC3 the time and time zone needs to be configured. Use the
Crestron Toolbox to connect to the MC3, refer to “Establishing Communication” on
page 19 for additional details. Select Functions | System Clock… and make the
appropriate changes.
Configuration can be completed through the use of the Web based setup. The
following screen appears on the Web page after establishing communication.
Navigate the screens and make the appropriate selections. To access the
configuration pages, enter the IP address of the controller in your web browser
followed by ‘/setup’ (e.g., ‘http://172.30.168.19/setup’)
Initial Opening Screen
Click the Setup button to display the “MC3 Setup” screen.
22 • 3-Series Control System™: MC3 Operations Guide – DOC. 7095D
To Next Page
Loading...
Need help?
General
