Regulatory Compliance
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Industry Canada (IC) Compliance Statement
As of the date of manufacture, the MC3 has been tested and found to comply with specifications for CE marking
and standards per EMC and Radiocommunications Compliance Labelling.
A portion of the code in this product is covered by the Microsoft
®
Public License (Ms-PL), which can be found at
www.microsoft.com/opensource/licenses.mspx
.
Crestron, the Crestron logo, 3-Series Control System, Cameo, Cresnet, Crestron e-Control, Crestron Mobile, Crestron Toolbox, D3 Pro, Fusion
RV, infiNET EX, Isys, SIMPL+ and SystemBuilder are trademarks or registered trademarks of Crestron Electronics, Inc. in the United States
and other countries. Apple, iPad, iPhone and Mac are trademarks of Apple Inc., registered in the U.S. and other countries. EMerge Alliance
and the EMerge Alliance logo are either trademarks or registered trademarks of Emerge Alliance Corporation in the United States and/or other
countries. Microsoft, Internet Explorer and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United
States and/or other countries. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks
and names or their products. Crestron disclaims any proprietary interest in the marks and names of others.
©2011 Crestron Electronics, Inc.
To Next Page
Loading...
