Crestron AM-3200 - Page 30

27 • AirMedia® Series 3 Receivers Product Manual — Doc. 9020C
l
Wireless Access Point: The device can be used as a Wireless Access Point (WAP) so that
users can present wirelessly without using a corporate Wi-Fi network.
NOTE:Wireless Access Point functionality is not available on the AM-3200. It is only
available on Wi-Fi network capable AirMedia receivers.
o
Wireless Access Point Mode: Turn on the toggle to enable the receiver to operate as
a Wireless Access Point
o
Name/SSID: Enter a name for the wireless network.
o
Security Key: Enter a security key to connect to the wireless network.
NOTE: The wireless network name and security should each be 22 characters or
fewer for optimal presentation on a display device and/or a connected touch
screen.
o
Security: Select an encryption key type to be used by the wireless network.
NOTE: When WPA2 is selected, WPA2-PSK is used by default for security key
encryption.
o
Auto Launch AirMedia Landing Page: Turn on the toggle to automatically launch a
web browser and redirect the user to the AirMedia landing page upon connection to
the wireless access point.
o
WiFi Mode: Select 2.4GHz Only or 5GHz Only from the dropdown list to use either a
2.4GHz or 5GHz frequency band. Select Concurrent to use dual-band frequencies.
o
2.4GHz Channel: Select the channel number. If 5GHz Only is selected in the WiFi
Mode field, then this field will not be editable.
o
5GHz Channel: Select the channel number. If 2.4GHz Only is selected in the WiFi
Mode field, then this field will not be editable.
NOTE: Set either channel to 0 (Auto) to enable automatic channel selection.
o
2.4GHz Signal Strength: Select the signal strength for the 2.4GHz frequency band. If
5GHz Only or Concurrent is selected in the WiFi Mode dropdown list, then the signal
strength for the 2.4GHz band will automatically be set to 0.
o
5GHz Signal Strength: Select the signal strength for the 2.4GHz frequency band. If
2.4GHz Only or Concurrent is selected in the WiFi Mode dropdown list, then the
signal strength for the 5GHz band will automatically be set to 0.
l
Network Proxy Settings
o
Proxy: Turn on the toggle to configure the device for use with a proxy server.