Crestron AM-3200 - Services

35 • AirMedia® Series 3 Receivers Product Manual — Doc. 9020C
l
NTP Time Servers: With Time Synchronization turned on, use the provided table to enter
information regarding the SNTP server(s) used to synchronize the date and time for the
receiver.
o
Select Add to add a new SNTP server entry into the table.
o
Enter the following information for each entry:
n
Enter the SNTP server address into the Address text field.
n
Enter the SNTP server port into the Port text field.
n
Use the Authentication Method dropdown menu to select the authentication
method used to access the SNTP server (if one exists).
n
If an authentication method is selected, enter the key used to authenticate
against the SNTP server into the Authentication Key text field.
n
If an authentication method is selected, enter the ID for the key used to
authenticate against the SNTP server into the Key ID text field.
o
To remove an entry, fill the checkbox to the left of the table entry, and then select
Remove.
l
Configuration: The receiver's internal clock can be configured manually.
o
Time Zone: Select a time zone for the receiver using the dropdown menu.
o
Date Format: Select the format that the date will appear on the display device
using the drop-down menu (MDY, DMY, or YMD).
o
Time Format: Select the format that the time will appear on the display device (12
hour or 24 hour).
o
Date: Select the date for the receiver using the pop-up calendar that is displayed.