Product Manual — Doc. 9020C AirMedia® Series 3 Receivers • 36
Control System
Select Control System to connect and configure a control system with the receiver. The receiver
can be controlled by a Crestron control system or by a virtual control system's SIMPL or SIMPL#
program.
System Setup – Control System
l
Encrypt Connection: Turn the toggle on to use SSL encryption for communication with the
control system. SSL can be used with or without a CA certificate. When Encrypt
Connection is toggled on, the username and password for the control system is required.
l
Control System Username: The username for the control system.
l
Control System Password: The password for the control system.
l
IP Table: Select Add to add an IP table connection between the device and the control
system.
o
IP ID: Enter an IP ID for connecting the device to the control system.
NOTES:
n
The control system will search the related ID while entering the IP ID.
n
The IP ID must match the IP ID defined in the control system's SIMPL
Windows or SIMPL# program.
o
IP Address/Hostname: Enter the control system IP address or hostname.
o
Room ID: Enter a room ID to associate with the device (for connections with the
Crestron Virtual Control server-based control system).
To Next Page
Loading...
