Product Manual — Doc. 9020C AirMedia® Series 3 Receivers • 46
l
Flex Mode: Turn the toggle on when using the receiver with a Crestron Flex conference
system. Flex Mode disables the HDMI output from the AirMedia device unless a source is
active.
NOTE: When using the device in Flex Mode, Crestron recommends setting HDCP Mode to
Never. A connected touch screen must be set to communicate to the device at the IP ID
FD. In System Setup > Power Settings, Standby Mode must be set to Always On as
described in Power Settings (on page28).
Connected Devices
Select Connected Devices to configure settings for any connected devices such as displays, touch
screens, and/or occupancy sensors.
Settings Screen - Connected Devices
Select the + (plus) icon next to Connected Devices to display the following device settings.
Settings Screen – Connected Devices (Connected Devices)
A list of connected devices is along with each device's Name, Type, Model, and Status . Select the
edit button to modify the connected device's settings. Select the test driver button to
send commands to a display device to test the driver's functionality.
To Next Page
Loading...
