Crestron DigitalMedia Room Controller DM-RMC-100 - Multimedia Display Interface

Crestron DM-RMC-100 DigitalMedia™ Room Controller, CAT
Multimedia Display Interface
A single HDMI digital AV output port is provided on the
DM-RMC-100, supporting HDMI with HDCP, Deep Color and 3D,
handling WUXGA computer resolutions and 1080p60 HDTV with
multi-channel HD lossless audio, all through a single connection. The
HDMI output can also handle DVI signals using an appropriate adapter
or interface cable
1
. In addition, there are RS-232, IR, and Ethernet control
ports provided for controlling the display device, plus two relays for
screen and lift control, and a SENS input for connection of an optional
current sensor or contact closure.
Multiple DM-RMC-100s may be installed to handle each display in a
multi-room distribution system, all fed from a central DM series switcher
(sold separately). Or, a single DM-RMC-100 can be fed straight from a
DM-TX-100 or other DM CAT transmitter (sold separately) to provide a
simple solution for extending a computer or AV signal to feed a single
display. The connection to the switcher or transmitter requires just one
DigitalMedia cable, with a potential cable length up to 450 feet (137
meters)
2
. In lieu of a central DM switcher, the DM-RMC-100’s LAN port
may be used to connect over Ethernet to a 2-Series control system if
needed.
1. HDMI requires an appropriate adapter or interface cable to accommodate a DVI
signal. CBL-HD-DVI interface cable available separately.
2. For DigitalMedia CAT wiring, use DM-CBL DigitalMedia Cable. Up to two DM
Repeaters (model DM-DR, sold separately) may be required. Refer to the latest
version of the Creston DigitalMedia Design Guide (Doc. 4789) for complete
wiring guidelines.
Operations & Installation Guide – DOC. 6743-1F Room Controller, CAT: DM-RMC-100 • 3