DigitalMedia™ Room Controller, CAT Crestron DM-RMC-100
Firmware
Firmware files may be distributed from programmers to installers or from
Crestron to dealers. Firmware upgrades are available from the Crestron
Web site as new features are developed after product releases. For details
on upgrading, refer to the Crestron Toolbox help file.
Check the Crestron Web site to find the latest firmware. (New users may
be required to register to obtain access to certain areas of the site,
including the FTP site.)
To upgrade DM-RMC-100 firmware:
1. Do either of the following:
• If the DM-RMC-100 is connected to a DM switcher, use the
Device Discovery Tool in Crestron Toolbox to find the IP
address of the switcher.
• If the DM-RMC-100 is being used in standalone configuration
(i.e. without a DM switcher), use the Device Discovery Tool to
find the IP address of the DM-RMC-100.
2. Add the IP address to the Address Book in Toolbox.
3. Download the appropriate .puf file from the Crestron Web site to
your PC.
4. Double-click the .puf file. The Toolbox Address Book will open.
5. From the list in the Address Book, select the DM switcher (if the
DM-RMC-100 is connected to a switcher) or the DM-RMC-100 (if
the DM-RMC-100 is used in a standalone configuration), then
click OK.
Either of the following occurs:
• If the DM switcher was selected, a DM device list is displayed
that allows upgrading all DM devices connected to the
switcher.
• If the DM-RMC-100 was selected, a DM device list is
displayed that allows upgrading of the DM-RMC-100 only.
In the DM device lists that are displayed, the checkbox of any item
that needs to be upgraded is automatically selected.
6. Click Update.
7. After the process is complete, click Recheck to verify the upgrade.
30 • Room Controller, CAT: DM-RMC-100 Operations & Installation Guide – DOC. 6743-1F
To Next Page
Loading...
Need help?
General
