Crestron HDI-XSPA - Downmix

Loudness
The loudness feature can be set from the
Theater
menu. Perform the following to set
loudness:
1. Open the
Theater
menu as described in “Theater” on page 17.
2. Press up or down on the Nav Pad to highlight
Loudness: On
or
Loudness: Off
,
and then press the center button of the Nav Pad. The setting toggles between
On
and
Off
.
Equalizer
The HD-XSPA can use a custom equalization setting that is created in Crestron Toolbox.
Perform the following to set the equalization:
1. Open the
Theater
menu as described in “Theater” on page 17.
2. Press up or down on the Nav Pad to highlight
EQ
, and then press the center button
of the Nav Pad. The
Equalizer
screen is displayed.
Equalizer Screen
3. Press up or down on the Nav Pad to highlight the desired setting, and then press
the center button of the Nav Pad. The display returns to the previous screen.
NOTE:
The
Custom
setting can only be configured with Crestron Toolbox.
Direct Mode
Direct mode is used to bypass any signal processing.
NOTE:
When operating in Direct mode, speaker protection is disabled.
Perform the following to set Direct mode:
1. Open the
Theater
menu as described in “Theater” on page 17.
2. Press up or down on the Nav Pad to highlight
Direct Mode: On
or
Direct Mode:
Off
, and then press the center button of the Nav Pad. The setting toggles between
On
and
Off
.
Downmix
The
Downmix
section of the
HD-XSPA
menu provides controls for managing the audio
settings for the downmix output. To open the
Downmix
menu, press up or down on the
Nav Pad to highlight
Downmix
, and then press the center button of the Nav Pad. The
Downmix
menu is displayed.
Equalizer
Flat
Custom
20 • HD(I)-XSPA: 4K UHD Surround Sound AV Receiver Supplemental Guide – DOC. 7448E