Cromptons Spinna Winna - Page 12

Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 12 of 31
PROBLEM POSSIBLE CAUSE SUGGESTED REMEDY
Lamp failure. Replace lamp.
See section 5.6 page 20.
One or more playfield
halogen lamps are not
working while others are.
Output fuse blown. Replace output fuse.
See section 5.7 page 21.
Distribution P.C.B. failure. Replace distribution P.C.B.All halogen lamps are not
working.
Transformer failure. Replace transformer.
The volume is set too low. Increase the volume.
See section 3 page 10.
Speaker failure. Replace speaker.
There is no sound.
Main control P.C.B. Check the information display
to ensure the software is
running. If not try reset.
See section 6 page 26.
The software is displaying a
fault condition on the
machine.
Check the information display
in the master section for an
error description.
The validators have not been
primed as described in the
‘QUICK START GUIDE’
Prime the validators with a
coin of play.
See section 3 page 7.
The validators are not
adjusted to the correct
sensitivity.
Re-adjust the validator
sensitivity.
See C.D.S. manual.
I have a C.D.S. mk4
validated coin entry that does
not accept coins.
Validator failure Replace validator.
The software is displaying a
fault condition on the
machine.
Check the information display
in the master section for an
error description.
I have a C.D.S. mk5 un-
validated coin entry or a
sliding coin entry that does
not accept coins.
There is a coin jam in the
chute.
Release jammed coins.
See section 5 page 23.
The software is displaying a
fault condition on the
machine.
Check the information display
in the master section for an
error description.
The flipper wheel is not
rotating when the coin is
inserted.
Check for any foreign object
or obstruction which may be
jamming the wheel.
Flipper motor failure. Replace flipper motor.
See C.D.S. manual.
Motor control P.C.B. failure. Replace P.C.B.
See C.D.S. manual.
Coin exit sensor failure Replace sensor.
See C.D.S. manual.
My coin entry device does
not flip coins properly after
accepting a coin.
Bad adjustment of C.D.S.
wheel flipper.
Re-adjust C.D.S. wheel
flipper.