Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 19 of 31
5.5 Replacing a top sign florescent lamp
You will need…….
• A Philips screwdriver.
• Florescent lamp part No. S100176.
Disconnect the machine from the mains
supply before starting this procedure.
Remove the plastic caps from both ends
of the top sign by unscrewing and
removing the two retaining fasteners as
shown.
Disconnect the end cable connections to
the lamp and remove the lamp from the
retaining clips.
Feed the lamp out through the cut-out on
either side of the top sign as shown.
Feed the new lamp back into position
ensuring that it is clipped securely in
place and the end cable connections are
re-attached.
Replace the plastic caps both ends using
the end cap fixings.
Retaining fasteners
To Next Page
Loading...