Crown Boiler PHNTM080 - Page 55

53
6. InstallationsusingexiblePolyue(VentOptions35,36):
 RefertoSelkirkPolyueInstructionsforassemblyofallexcomponentsincludingthechimneycapandtheadaptorto
 rigidPolyueatthebaseofthemasonryorBventchimney.Inaddition,observethefollowingrequirements:
 a. RefertotheappropriateVentoptioninTable7.21foralistoftheprincipleexcomponentsrequired.Rigidventpipeby
the same manufacturer will also be required for the run from the boiler to the base of the chimney.
 b. Polyuemaynotbeusedinairchaseapplications.


 


  
  
  
FIGURE 7.41: POLYFLUE PIPE LOCKING BAND INSTALLATION