Crown Vrack 4x3500 - Input Wiring Modes; AES Mono 2 and AES Mono 3 Modes

Operation Manual
page 16 page 17
Operation Manual
Input Wiring Schematic
Rack Input Wiring Schematic
NETWORK AES 1
+
2 AES 3
+
4 ANALOG 1 ANALOG 2
IN
NETWORK
OUT
AES XLR
to VDrive
On-Amp
No VDrive
or AES to
Amps
VDrive through
Ethernet In Only
Send to
Network
Output
OFF
IN OUT IN OUT IN OUT IN OUT
VDrive output switch will send
buffered VDrive signal to the network
out or just network signals.
SW Pos 1 - No VDrive or AES to amps
(Direct Patch to Amps
SW Pos 2 - VDrive from Network in only
SW Pos 3 - AES XLR on Ramp to Drive
AES 1+2
Failover
AES 1+2
AES 1+2
AES 3+4
Network
AES 3+4
Network
Network
Buffered
AES 1+2
AES 3+4
AES 1+2
AES 3+4
AES 3+4
Failover
***Please note, the AES3 signal is distributed via VDrive from the input panel to the amplifiers. Therefore, any time AES3 is patched
directly to the input panel, VDrive must be enabled via the software or front panel display of the amplifier for the AES3 signal to be seen
by the amplifier. (see page 21 for more details)
I-TECH 4x3 500 | 2300 W
REG. U.S. PAT. OFF. 5,657,219 6,504,3 48 6,909,3 21
7,283,379 7,557,622 7,919,998 7,778,324 7,521,936
CLASS 2 OU TPUT WIRING
I-TECH 4x3 500 | 2300 W
REG. U.S. PAT. OFF. 5,657,219 6,504,3 48 6,909,3 21
7,283,379 7,557,622 7,919,998 7,778,324 7,521,936
CLASS 2 OU TPUT WIRING
I-TECH 4x3 500 | 2300 W
REG. U.S. PAT. OFF. 5,657,219 6,504,3 48 6,909,3 21
7,283,379 7,557,622 7,919,998 7,778,324 7,521,936
CLASS 2 OU TPUT WIRING
Input Wiring Modes
AES Mono 2
AES Mono 3
Analog Mono 1
Analog Mono 2
Analog Stereo
AES Mono 1
AES Mono 2
AES Mono 3
AES Mono 4
AES Stereo 1&2
AES Stereo 3&4
AES Mono 1+2
AES Mono 3+4
Analog Mono 1
Analog Mono 2
Analog Stereo
AES Mono 1
AES Mono 2
AES Mono 3
AES Mono 4
AES Stereo 1&2
AES Stereo 3&4
AES Mono 1+2
AES Mono 3+4