Why is my Crystal Instruments Coco-80 Measuring Instruments sensor input lower than expected?
The sensor input might be lower than expected because the sensor channel has not been set correctly. Verify that the Measurement Quantity and Sensor Sensitivity are correct.
What to do if Crystal Instruments Measuring Instruments tachometer is not detected or reading unstable?
If the tachometer is not detected or the reading is unstable, it could be due to the following reasons: 1. The tachometer threshold is not properly set. To resolve this, press Setup and select Tacho/RPM. Select Read from the tachometer measurement and press F1 (Tacho Setup) to configure the tachometer channel. Press F2 (Pulse Detection) to set the trigger level. Set the Detection Threshold around 80% of the peak voltage and press F6 (Apply). 2. The tachometer is on the wrong channel. Ensure that the tachometer is connected to Channel 1 on the CoCo.
How to fix Crystal Instruments Measuring Instruments EDM installation failure?
EDM installation might fail if the user account does not have administrator privileges. To solve this: * Check with your IT administrator to verify that the account can install programs. * Contact IT to have them install EDM.
How to fix Crystal Instruments Coco-80 menus that are cut off?
If menus are cut off, the scroll bar extends beyond the viewable area, or buttons are missing from menus, it is likely because Windows text scaling is set higher than 100%. To fix this: Windows 7/Vista: Open Control Panel -> Display. Set text size to 100% Windows XP: Right-click on desktop and select Properties. Click the Appearance tab. Set Font Size to Normal.
What to do if Crystal Instruments Coco-80 won't connect to LAN for update?
If your CoCo won't connect to a LAN to update, consider the following: * Verify all connections are secure. * If the network is secured, contact your local IT administrator for access. * If the CoCo IP settings are not configured properly, enter the main menu by pressing Setup. Select Connections, then F5 (IP Setup) to configure the Ethernet connection. Contact your network administrator for the correct LAN settings.
General| ADC Resolution | 24-bit |
|---|---|
| Operating System | Embedded Linux |
| Sampling Rate | 102.4 kHz |
| Frequency Range | 0 - 40 kHz |
| Output Type | BNC |
| Connectivity | Ethernet, USB |
| Data Storage | USB drive |
| Interface | Ethernet, USB |
| Power Supply | 10 - 36 VDC |
To Next Page
