Crystal Instruments Coco-80 - Coco Measurements; Select Measurement Mode

CoCo-80 Quick Reference
47
CoCo Measurements
There are two general categories of measurements that
can be taken by the CoCo while in VDC mode, Route
measurements and Onsite measurements. Route
measurements are taken at various points along a factory
route as defined in EDM. Onsite measurements are
measurements that are taken without reference to a
route.
Select Measurement Mode
Power on the CoCo by pressing the Power button and
allow the unit to run through its startup routine. When
the startup process is complete select VDC as the working
mode.
Enter VDC mode by pressing F1 (VDC) or by pressing
Enter.
Figure 48: VDC or DSA selection screen