CoCo-80 Quick Reference
61
Onsite Measurements
Onsite Measurements are used when a single Entry needs
to be recorded independent of a Route. Onsite
Measurements can be attributed to any Point in the active
Factory, or stored as a generic Onsite Measurement if
taken at a non-standard location.
An Onsite Measurement can be started mid-route by
pressing the Analysis key. Alternatively, when a Factory
has been selected Onsite Measurement can be selected
from the Setup screen.
Figure 61: Onsite Measurement via the Setup
menu
Configuring an Onsite Measurement
Unlike a measurement Point that has been defined in
EDM, Onsite Measurements will need all parameters
defined before taking a measurement. This process begins
by selecting the type of measurement that will be taken.
To Next Page
Loading...