CoCo-80 Quick Reference
60
Peak detection can be enabled for a Cursor by pressing
and holding Up. While holding the Up button, two dashed
lines will appear, one on either side of the cursor. The
peak value between these two dashed lines will be
detected and its X and Y values will be displayed. To clear
the detected peak, press Down.
Figure 60: Using a Cursor for peak detection
Adding two Cursors to a Spectrum trace allows for
calculations of RMS and THD values for the frequency
range between the two Cursors. Pressing Shift will change
which Cursor is controlled by the navigation buttons.
F6 (Start Meas.)
To start collecting data at a measurement Point press F6
(Start Meas.). Depending on the settings defined in F2
(Param) -> Save Option the measurement will be saved
and the next Point can be started.
If at any time a measurement needs to be taken on a
Point that is not defined in the current Route, an Onsite
Measurement can be taken by pressing the Analysis key.
To Next Page
Loading...
