CoCo-80 Quick Reference
30
Upload and Download Options
Upload Options
When uploading Factory information to the CoCo,
duplicate or older information can be handled in two
different ways. Uploading can be done in Replace Mode
or in Combine Mode.
Replace Mode
When the Factory structure and Routes are synchronized
between EDM and the CoCo there are two options that
need to be considered. If a new Route has been created
that encompasses all the Machines and measurement
Points, or if Machines have been changed out with spares,
the Upload process should include the Replace mode
option. This will replace the entire Factory in the CoCo
with the new Factory and Routes that are associated with
that Factory.
For example, if Machine 3 on the factory floor is being
replaced with a spare that has been overhauled, the
vibration and other monitoring data in the database
should not be mixed between the two machines. Machine
3 has been taken out of service and is being replaced with
Machine 2, and the Factory has been updated in EDM to
reflect this change of equipment. When uploaded to the
CoCo in Replace mode, Machine 2 measurements will
take the place of all Machine 3 measurements.
Combine Mode
If adding new Machines to the Factory, it is not necessary
to entirely replace the Factory during an upload. For
To Next Page
Loading...