CoCo-80 Quick Reference
51
System Calibration: Launches the calibration
routine.
Audio: Set the preferences for audio feedback,
headphone volume, and microphone input.
F6 (DSA): Changes the working from VDC to DSA
mode. DSA mode will not be covered by this
reference guide.
Route Measurements
Routes are predefined collections of measurement Points
defined through EDM. A Route is a subset of a Factory and
can only record data associated with the Factory it
belongs to.
From the main Setup menu select Route to load the list of
Routes associated with the active Factory.
Figure 51: CoCo Setup screen
Select a Route from those available and press F6 (Activate
Route).
To Next Page
Loading...
