CoCo-80 Quick Reference
52
Figure 52: Available Routes
The Route will be displayed, outlining the Points that
measurements will be taken at as well as the number of
Entries associated with that Point.
To begin, select the Route name and press F6 (Activate).
The Route can also be started at any Point or Entry by
selecting the desired point and pressing F6 (Activate).
The organization of the Route in the CoCo is shown in
Figure 53. The top level is the active Route. The next level
of the display is the Machine-Point. The Machine is the
physical piece of equipment being measured, and the
Point is the location of the Machine where the
measurement will be taken. Expanding the Machine-Point
will display the Entries for that Point. The entire Factory
structure and Route is created in EDM.
To Next Page
Loading...
