ENGLISH
15. REPLACING THE CERAMICS
For machines in ceramics disassembly and reassembly of individual parts must be done taking great care as
not to damage the parts.
Use both hands to remove the ceramics (fig 16) and lift each piece upwards, vertically, ALWAYS remove the
upper ceramics and work downwards, ensuring not to bend single supports (fig. 17).
To reassemble the pieces do the opposite, ensuring that every hole of the ceramic meets the support, before it
is pushed downwards, using little force until the part is in place.
16. CARE AND MAINTENANCE
To ensure correct functioning and maximum efficiency of the stove, carry out the following weekly maintenance
operations
THE FOLLOWING OPERATIONS NEED TO BE DONE WHEN THE STOVE IS COLD
PELLET CRUCIBLE
For correct functioning of the machine it is important that the crucible (fig.19) is emptied after every use (once
cold). After every three uses it is advisable to take it out, remove all the ash and pellet residue and to correctly
reposition it.
The crucible has a mesh that can be taken out or put back according to the type of pellet and desired power
used: ask your authorized After Sales Service Centre how to use the mesh correctly.
Fig.20
To Next Page
Loading...
