13
4. Replace the lower a-arm spacer, lower a-arm rod
end, lower a-arm spacer and upright plate.
5. Using loctite 262 replace the four ¼ - 20 x ½ SHCS
and tighten.
6. Replace the ½ - 20 nyloc nut and tighten.
7. Install the Half Shaft nut using Locktite.
Torque the nut to 200 FT-LBS.
8. Replace the wheel assembly.
9. Remove the bike from the lift.
Torque Specifications:
1. ¼ - 20 x ½ socket head cap screws 9 ft. - lbs.
2. ½ - 20 nyloc nut 45 ft. - lbs.
3. Lug nuts 70 ft. - lbs.
To Next Page
Loading...